Pneumaticraft Pressure Chambers for Zoomers

Some people on Sevtech needed help with their chamber, so I'm making this guide!

Step 1: Construction.

The edges of the chamber, 3x3x3 or 5x5x5 need to be made out of "Pressure Chamber Wall" Like this:



The sides of the chamber need to be filled in with "Wall" or "Glass" with 2 "Interface" and 1 "Valve"

The finished chamber (5x5x5) will look like this:



The valve is on the center block of the right side. Make sure that one of the interfaces has the "O" facing the INSIDE of the chamber, and the other has the "O" facing the OUTSIDE of the chamber.

There are 3 GUI elements to the chamber, the chamber itself, and the 2 interfaces. The chamber:



And the interfaces:



Step 2: Input

You will be inputting pressure and items. Pressure goes in using pressure tubes and air compressors:



The best way to input items is with a chest and an omnidirectional hopper:



Step 3: Output

You will NEED to PULL items out of the output interface. Also make sure you set the filter so that items stay in the chamber to get crafted:



You can remove the filter after the items have crafted, and they will be ejected into the interface. Once there, use whatever you want to Pull the items from the interface and into storage.

And that's it. Any questions just leave a comment!

 

Just remember, as with all multiblocks that you keep everything within one block.

Some times you might find your multiblock has run out of air over time, if you have left your base and if you haven't chunkloaded the multiblock. This was first seen on 1.6.4 and it is still happening from time to time on SevTech as well. You will then have to break one of the frame blocks and re-form it. But remember to remove any upgrades from the multiblock itself and the input/output ports first as we have seen some incidents of upgrades being lost when the multiblock is broken.

It is also important to remember to always sing “Under Pressure” whenever you wait for the chamber to get to sufficient PSIs to make those pesky capacitors and transistors.

 

The funny thing is 90% of users don't use the forums or even have an account not saying making this was utterly pointless just that it most likely won't be used a lot but I could be wrong

 

But now you know what they are missing out on.

 

Also this guide is only for the Sevtech version. Newer versions have made some tweaks to the 'heat' mechanic that makes it hard to run flux compressors at max pressure without a crapton of compressed iron blocks as a heatsink.