I am using a filler to clear an area under my base, I have set for a complete clear, but the filler is clearing the 3x3 chunk area and 6 layers randomly rather than starting at the top and working down. Every so often about 1/12 it will clear the block in the correct order, but the rest seem totally random. With this method I am sure I am losing many ores as I am unable to check what has gone.
It seems to be working, but very slowly and on random blocks in the assigned area[DOUBLEPOST=1421715426,1421715285][/DOUBLEPOST]I have 3 dynamos on the filler, all with 2 x4 upgrades in and it seems to do one block every 15 secs, I have had it going for about 6hrs so far and not even covered the 1st layer, but blocks missing from other layers, previously I could do the same set up and it would be done in <10 mins
ok will try that, I tried it earlier with no luck, but will reset it all to see if it works[DOUBLEPOST=1421716501,1421716246][/DOUBLEPOST]Still very slow and random blocks
ok, its a strange problem I have never seen before, it is working, but so slow and randomly, will just have to let it run and do all my other levels manually. I will try and get another player to place it and see if that does anything
Think they switched it so it went from top to bottom, but mine was still strange, it seemed to remove dirt first then gravel then go totally random. Did not even think it was that inteligent to know the block differences. Oh well it worked and cleared the area I wanted.
