Implemented ME level Emiter

Discussion in 'The Dark Trilogy' started by Fousicek, Mar 4, 2015.

  1. Fousicek

    Fousicek Well-Known Member

    Messages:
    359
    Likes Received:
    15
    Local Time:
    5:38 AM
    Is there a way how to make EnderIO machines stack next to eaxh other to react to its proper ME level Emiter?

    Because right now i have a line with machines and i can put ON/OFF three Furnaces using only one ME level Emiter which is not intendet purpose. Try to put covers on it. Does not seem to work.

    Any Ideas ? thx
     
    Fousicek, Mar 4, 2015
    #1
  2. LucidTheStick

    LucidTheStick Well-Known Member

    Messages:
    3,143
    Likes Received:
    1,327
    Local Time:
    11:38 PM
    Can you post coordinates and screenshots of the setup?
     
    LucidTheStick, Mar 4, 2015
    #2
  3. Fousicek

    Fousicek Well-Known Member

    Messages:
    359
    Likes Received:
    15
    Local Time:
    5:38 AM
    OK .

    Here is a screanshot.

    [​IMG]

    And when the middle one is activated the other two touching the middle alloy smelterry active also even when the lvl Emiter is not activated
    [​IMG]
     
    Fousicek, Mar 4, 2015
    #3
  4. MaelstromPhoenix

    MaelstromPhoenix Well-Known Member

    Messages:
    441
    Likes Received:
    119
    Local Time:
    5:38 AM
    The problem is with the level emitters. They will emit to the block its facing and the left and right faces of that block as well. You can place a block and then a redstone torch on it to make it work properly but it takes up lots of space.
     
    MaelstromPhoenix, Mar 4, 2015
    #4
  5. Fousicek

    Fousicek Well-Known Member

    Messages:
    359
    Likes Received:
    15
    Local Time:
    5:38 AM
    aaaaaaa why why why why why why --------- and it looked so compackt and cool.

    Nwm. Ill use bundelt conduits and put the lever emiters down under it.
     
    Fousicek, Mar 4, 2015
    #5

Share This Page