Done More crashing.

Discussion in 'Infinity' started by Asapps, Jul 12, 2015.

  1. Asapps

    Asapps Well-Known Member

    Messages:
    416
    Likes Received:
    51
    Local Time:
    4:51 AM
    It shows 3 me systems causing lag. The most laggy one is from willjust5's me system. Could and mod/admin get on and fix them? That's about 10 tps of the lag
     
  2. Matryoshika

    Matryoshika Well-Known Member

    Messages:
    1,193
    Likes Received:
    606
    Local Time:
    10:51 AM
    Paging @Senior Moderator to investigate and optimize if possible

    Next time @Bloodbath12321 please also upload a screenshot of the ME systems, as they appear on a timed cycle, so it is hard for the Senior Moderators to know which ones require optimization, until they are seen in chat again.
     
  3. Asapps

    Asapps Well-Known Member

    Messages:
    416
    Likes Received:
    51
    Local Time:
    4:51 AM
    Yes, I know. My apologies.
    .
     
  4. willjust10

    willjust10 Well-Known Member

    Messages:
    12
    Likes Received:
    1
    Local Time:
    1:51 AM
    As most of my ME system is offline, I doubt it is mine. However you all seem like attacking my base every few minutes none the less. Can I actaully get recommendations instead of just "fix it or we will delete everything you have worked on." Deleting stuff is not fixing the problem. If I break a leg, I do not kill myself to fix my broken leg. I have looked around as suggested by matry but have seen nothing. Logistical pipes for autocrafting might just be my only option at this point.

    Could someone PLEASE explain what the number before AE systems causing lag means?
     
    Last edited by a moderator: Jul 13, 2015
  5. Matryoshika

    Matryoshika Well-Known Member

    Messages:
    1,193
    Likes Received:
    606
    Local Time:
    10:51 AM
    First and foremost, we will never outright delete/destroy a players property, unless they abhorrently go against our rules. Rules - MineYourMind 5.0

    As said, I requested a senior to investigate & optimize any ME systems that are causing server-strain.
    You can read this to make sure that your own systems are optimized. Performance Guide — MyM-Wiki 0.0.1 documentation

    The higher the number, the higher the strain is on the server. Even a low "1" is rather bad, as most systems are not seen at all during these scans.
     
  6. willjust10

    willjust10 Well-Known Member

    Messages:
    12
    Likes Received:
    1
    Local Time:
    1:51 AM
    My system never changes and yet sometimes its 9 and othertimes its 40-50. It seems to be correlated to tps. So how exactly is it calculated?
     
  7. Xfel11

    Xfel11 Consultant

    Messages:
    635
    Likes Received:
    157
    Local Time:
    10:51 AM
    yes, this is correlated to TPS, but always remember that correlation isn't causation. In this case, it's actually the other way round: IF your ME system is taking too much load, the server TPS will go down too naturally. The load of your system doesn't only depend on the setup, but also on the way you use it. If you have a big autocrafting system you only switch on sometimes then you'll experience varying profile readings.
     

Share This Page